ports
/
contrib
3
3
Fork 2
Code Issues Pull Requests Activity
contrib/easyeffects
History
Tim Biermann 452ab154ab
easyeffects: 7.1.5 -> 7.1.6 		2024-03-30 17:59:32 +01:00
..
.footprint easyeffects: 7.1.0 -> 7.1.1; new dependency: ladspa 2023-10-28 11:04:10 +02:00
.signature easyeffects: 7.1.5 -> 7.1.6 2024-03-30 17:59:32 +01:00
Pkgfile easyeffects: 7.1.5 -> 7.1.6 2024-03-30 17:59:32 +01:00
README.md
…
post-install [notify] easyeffects: 6.1.5 -> 6.2.1; new dependencies: fmt and libadwaita 2022-01-07 12:53:32 +01:00

README.md

contrib/pulseeffects README

Building pulseeffects

Building and successfully using pulseeffects requires you to build pipewire including pulseaudio support. Therefor, pulseaudio needs to be around before you install pipewire. After that, pulseeffects can be successfully installed and used.

It's recommended to set the following setting in /etc/pkgmk.conf:

PKGMK_IGNORE_NEW="yes"

This will ignore any new files found in a footprint. This is needed, because it's expected to produce more files than a minimal build for some individual ports, e.g. contrib/pipewire, contrib/gst-plugins-bad, etc..

Another setting to consider is the following in /etc/prt-get.conf:

runscripts yes

Alternatively, you will need to watch out for ports that would run pre-/post-install scripts yourself and execute them in order to expect a fault-free environment.

After considering those steps, if you manually want to ensure that everything will be fine, the steps should be as follow:

  1. prt-get depinst pulseaudio
  2. prt-get depinst pipewire
  3. prt-get depinst pulseeffects

Please take a look at contrib/pipewire/README for more instructions on how to setup a pipewire environment. Make sure to enable it for handling pulseaudio requests and you are good to go.

Optional dependencies:

About the optional dependencies (list borrowed and enhanced from archs PKGBUILD ):

  • calf - limiter, compressor, exciter, bass enhancer, and others
  • lsp-plugins - equalizer
  • mda.lv2 - loudness
  • rubberband - pitch shifting
  • rnnoise - noise supression using a recurrent neural network
  • zam-plugins: maximizer

You will need to rebuild gst-plugins-bad after installing most of any of those optional dependencies, pulseeffects will then pick them up and make them available, otherwise, all the plugins are shown but none of them are useable.

Issues

  • If you run into issues, please try removing GStreamer's cache rm -rf ~/.cache/gstreamer-1.0 and have a look at the debug output with G_MESSAGES_DEBUG=pulseeffects pulseeffects.
  • You can check what plugins your current gstreamer build offers with gst-inspect-1.0 | grep -i calf | grep -i limiter

Additional information

Additional info from the official FAQ over at the projects official wiki

// vim:filetype=markdown

// End of file